Digitizer

Digitizer

Easy, accurate inputting of patterns into your Gerber CAD system

You can quickly and efficiently

Here are some of the types of

You can use special digitizing

input pattern pieces into your

information you can enter into the

techniques for a variety of pattern

AccuMarkTM system in several ways:

system:

requirements, such as nested,

· Grading information and data

through SilhouetteTM, Pattern DesignTM,

copied, or mirrored pieces. All of

· Piece outline and internals, such as

or by digitizing.The digitizer

the information entered into the

stripe and plaid lines, and drill

workstation consists of a digitizing

digitizer is directly stored in the

table with menu, and a cursor.The

locations

AccuMark system, where it is then

digitizer allows you to enter

· Piece identification

ready for pattern modification and

information that describes a pattern

· Notch type and location, up to

the marker making process.

piece.

five different kinds per piece

Using a predefined grade rule

· Piece labels and special point

table as a reference, an entire range

information, such as instructions for

of sizes can be graded from a single

the GERBERcutter® system

base size pattern during digitizing.